2 Way Digital Aux Input Switch & 3 Position Auxiliary Input for Cycle Analyst V3.1

Regular price

Please note that this switch requires that your Cycle Analyst is running firmware version 3.1 or above.

This combination 2 way digital and 3 position auxiliary input can be configured to control two of the following Cycle Analyst V3 parameters:

  • Mode presets
  • Amps limit
  • Speed limit
  • Power limit
  • ThrO limit
  • PAS level

Specifications:
  • Cable length: ~50cm
  • Connector : JST-SM 3-pin male
  • To fit handlebar diameter: 22mm

Installation:

  1. Mount the switch on your handlebar.
  2. Connect the switch to the WHITE 3-PIN FEMALE JST-SM Cycle Analyst V3 connector.
  3. Confirm that your Cycle Analyst V3 is running firmware version 3.1 or above. If your Cycle Analyst is running an earlier firmware version, you will be required to update it using a programming cable, available from Grin Cyclery (ebikes.ca).
  4. Configure your Cycle Analyst V3 with the following settings:
  • Analog Aux Settings > AuxA Control Type > [3-Pos Sw]
  • Analog Aux Settings > AuxA Input Function > [SELECT FUNCTION]
  • Analog Aux Settings > Switch Med Level > [SET MED LIMIT PERCENTAGE] (not applicable if ‘AuxA Input Function’ is set to ‘Presets’)
  • Analog Aux Settings > Switch Low Level > [SET LOW LIMIT PERCENTAGE] (not applicable if ‘AuxA Input Function’ is set to ‘Presets’)
  • Digital Aux Settings > AuxD Control Type > [2 Btn]
  • Digital Aux Settings > AuxD Input Function > [SELECT FUNCTION]
  • Digital Aux Settings > Number of Levels > [SET NO. OF LEVELS]
  • Digital Aux Settings > Low Percentage Limit > [SET LOW PERCENTAGE LIMIT]


*Cycle Analyst V3 not included.